Verwenden eines ClampTite-Tool

Step 1

• Insert end of wire into front pin on the left hand side
• Bring wire over the nose and in front of forward pin on the right hand side
• Wrap wire around hose (as many wraps as desired)
• Bring wire over the top of the wraps and around the rear pin on the right hand
• Take wire over the top of the tool and around the pin on the left hand side

Step 1 (Alternative)

• Place loop of wire around nose and twist to tighten
• Wrap wire around hose (as many wraps as desired)
• Bring wire over the top of the wraps and around the rear pin on the right hand side
• Take wire over the top of the tool and around the pin on the left hand side

Step 2

• Turn wing nut to tighten
• When clamp has reached desired tension, rotate tool 180 degrees to lock clamp
• Loosen wing nut and remove clamptite tool
• Clip wire ends about 1/4 inch from clam and push down towards hose

Step 1

• Cut wire to length (4 times around project plus 12″ for tool)
• Fold wire in half, tape or wire nut ends together
• Wrap around hose where you want a clamp
• Tuck ends through the loop

Step 2

• Continue to wrap around in the same direction; tuck thru loop again and remove tape or wire nut
• Place tool as shown with wire over front pin and around rear pin
• Twist ends together tightly about 6 twists as close to the body of the tool as possible

Step 3

• Place notch at end of tool against the wire loop
• Turn wing nut clockwise to tighten (right hand threads)

Step 4

• Rotate tool over to lock the clamp bending wires back over themselves
• Loosen wing nut and remove the clamptite tool
• Clip off wire ends about 1/4 inch from clamp and push ends down against the hose